Is a Prop considered an entity?

[Robert_d1968]

I have almost finished my map and structures along with the props involved. Now when I try to start the game it states entity mass must be at 1.0  But when I first made the map and played it a few times, it did not have this problem. 

What gives?

Thanks for any help you can provide.

Robert

[Staplers]

I'm going based off the manual but check to ensure which meshes are rigid bodies, which ones are intended to be static (non-moving) and otherwise ensure your props have the right physics property applied to them.

Some of this might be in relation to the automatic mesh collider generation (name a limb collisionhull vs collisionmesh or whatever it said, depending on if you want a static or mobile thing). Also, turning on gravity might be a great way to see if your prop is intended to be a part of the map or not. Or... it'll just fall regardless... idk. Haven't messed around with it that much. Ensure you've studied the physics details tho.

[Robert_d1968]

I found the Problem, something wrong with the files system. Had to resort to some early backups, but it seems okay now.

This pos mouse I have sucks butt, causing all kinds of trouble in leadwerks.

Thanks for the help though. much appreciated.

 

Robert

[Robert_d1968]

This was telling me a light was an entity and I was like what?  so I deleted all of the config files and resorted to a backup of

Leadwerks.config to copy the  working directories to the config file, now it's back to normal, thank god.

 

Robert 

[Robert_d1968]

It kept telling me that an entity needed greater than 0 for mass, but it could not be done.

[Josh]

Not enough information to answer this I think

[Robert_d1968]

it was a mouse problem that caused this to happen. I'm getting a new mouse ASAP!

[Robert_d1968]

After the mouse messed up. It would report the Lights in the game as needing a mass greater than zero.

 

[Robert_d1968]

Is there an application for Checking the maps that you make for some type of corruption? I put props in the map for opening and closing the doors and it I put the scripts in the door. you can manually activate the doors, but it complains about the light enitity's mass being less that zero, there is something wrong and I can't find it...

 

Robert

[Robert_d1968]

Like a floor plate with swept collision enabled and the door being place in the flow-graph editor. used to work, now the flow graph editor does not list a collision event to wire it up in the flow graph editor.

I deleted all the config files in leadwerks 4.6 and re-installed it but the same problems exist in it. even the previous maps have the same issues.

Robert

[Josh]

It would probably be best to upload an example map so others can try it. it is difficult to understand what is happening from the description.